A Viewer for Windows, ESP32 Projects, Cast, NotifyOnDemand, Push2Run and SetVol

So I just got a Google Home Mini today. And I believe I followed all the steps properly in the set up for Push2Run. However, it still doesn't seem to work for me.

When I say "Tell my computer to...", the Assistant recognizes it and says "OK, I told your computer to..." but nothing happens on my computer. In this case, I used the default "open the calculator" command. Nothing happens and there's also no session log registered.

Anyone know what I might have missed here?

When you open the Push2Run session log, the top of it should say this:

2018-11-24 19:31:41.081 - Started

2018-11-24 19:31:41.393 - Network status is up

2018-11-24 19:31:43.301 - Connection with Pushbullet established

Is that what you see?

Also, I would say to best thing to do is take another close walk thru the instructions at: https://www.push2run.com/setup.html

Having that said, if you previously had a pushbullet account (for example several months / years ago) but you have not used it in over a month, you will likely need to create a new one (as they seem to expire after a month of none use, with no easy way to re-instate them).

Hello,

I'm having the same problem. IFFT title is the same as Push2Run's Title Filter, PushBullet is connected to IFFT and Push2Run.

http://prntscr.com/lncy7u

http://prntscr.com/lncyc3

Session log:

2018-11-26 17:50:12.629 - Started with administrative privileges

2018-11-26 17:50:12.690 - Network status is up

2018-11-26 17:50:13.882 - Connection with Pushbullet established

I tried setting up from scratch but no success.

Appreciate your help!

Thanks,

Jason

Just wanted to follow up, I had started the Google Home setup (through my phone) with my main email. Since some apps required a gmail account that's where the confusion went. I restarted the setup and kept it all 1 email!

Sorry and thank you for a great app

jtr4in: glad you got it working and thanks for posting back, its quite possible others will run into the same thing so knowing your solution is rather helpful!

RobLatour wrote: ↑Sun Nov 25, 2018 4:38 pm Having that said, if you previously had a pushbullet account (for example several months / years ago) but you have not used it in over a month, you will likely need to create a new one (as they seem to expire after a month of none use, with no easy way to re-instate them).

i went to a trip overseas and when i got back and plug the home and it doesnt work, i follow the steps got the connection to pushbullet and even make a new account (put the new code) and nothing, any suggestions?

thanks!