A Viewer for Windows, ESP32 Projects, Cast, NotifyOnDemand, Push2Run and SetVol

As per "Cannot cast a text to my devices. Only to my own PC speakers." (thx seank)
Rob could you add a switch to specify the IP address for the PC running the cast software just in case the computer has multiple NIC's?

Hi, there is already a switch to cast to an ip, as an example:

cast -text "this is a test" -ip 192.168.1.123

a list of ips can be obtained via the command:
cast -inventory

However, I believe the issue you are having is that with the Hyper-V Default Switch enabled casting won't work.

I'm not yet sure why that is, or if I can force casting through a specific NIC. I'll need to take a deeper look.

I found this program https://r1ch.net/projects/forcebindip which says it will do the trick, although when I tried it, I could not get it to work with the Hyper-V adapter enabled.

Of course, with the Hyer-V adapter disabled, everything works fine with cast alone (and I don't even need the forcebindip program at all.

Having that said, my Google devices are on a separate network, so that is perhaps making it difficult for me to use forcebindip.

My google device I want to cast to is at 192.168.200.114. I tried:
ForceBindIP 127.0.0.1 "C:\Program Files\cast\cast.exe" -text "This is a test" -ip 192.168.200.114 -pause
ForceBindIP 192.168.200.114 "C:\Program Files\cast\cast.exe" -text "This is a test" -ip 192.168.200.114 -pause
ForceBindIP {xxxxxxxx-xxxx-xxxx-xxxx-xxxxxxxxxxxx} "C:\Program Files\cast\cast.exe" -text "This is a test" -ip 192.168.200.114 -pause

(the -pause is so that I can see the results. However, it would not be needed once it was working.)

In any case, if you have any better luck, please let me know.

ref: https://superuser.com/questions/1369902 ... twork-card
ref: https://www.howtogeek.com/117890/how-to ... work-card/

As an update.

I rebooted my PC and now I can use Cast just fine, even if with the Hyper-V virtual switch enabled.

Not sure why this is, I tried running a vm on Hyper-V to see if using it would make a difference. It did not, Cast runs just fine with or without Hyper-V actually running a vm.

I checked the cast executable, in case the forcebindip program had updated it in some way, but it was unchanged. In fact, I reinstalled Cast and it is still working fine.

The only other command I ran, from the c: prompt, was
route print
to see the priority order of my adapter cards - however, I can't see that having made a difference at all.

In any case, Cast is working fine for me and as I understand it is working fine for you too (with Hyper-V disabled).

If you have any additional problems, just let me know.