"no matching phrases" and "no matching enabled phrases"

Post by **RobLatour** » Wed Nov 25, 2020 9:57 pm

Release 3.4.1 adds a feature which allows you to run commands when there are:

1. no matching phrases, and/or
2. no matching enabled phrases.

The difference between "no matching phrases" and "no matching enabled phrases" is:

1. will trigger an action if the phrase you have spoken does not have a Push2Run card with a matching "Listen for" value,

2. will trigger an action if there is Push2Run card with a matching "Listen for" value, but the associated Push2Run card is turned "Off".

Below are screenshots showing how these commands can be used, along with the nircmd utility, to pop-up a message box detailing the phrase that was not matched.

: nomatchingphrases.jpg (71.21 KiB) Viewed 8103 times

: nomatchingenabledphrases.jpg (74.95 KiB) Viewed 8103 times

For more information on the nircmd, please see: https://www.nirsoft.net/utils/nircmd.html

Here are the Push2Run cards associated with the two screenshots above:

No_matching_phrases.p2r: (563 Bytes) Downloaded 716 times

No_matching_enabled_phrases.p2r: (587 Bytes) Downloaded 724 times